Notes:
– No transmitter is assigned to the receiver in its delivered state.
– Several transmitters can be assigned or deleted (max. 32 receivers) in
learn mode.
– A transmitter is alternately assigned (LED on) or deleted (LED off)
each time the button is pressed!
– The receiver‘s Function 1 is preset after assigning a transmitter to the
receiver. The function can be changed for every transmitter.
–
If no action takes place, learn mode will be terminated after 30s
Deleting All Transmitters
Function Programming
Note:
If no action takes place, function programming will be terminated
after 30 s.
Transmitter detection,
(e.g. press transmitter button)
Activate transmitter once
LED blinks orange – transmitter detected
Function setting,
(e.g. function 3)
LRN/SET button 3 x activated
LED blinks 3 x orange – function3
Parameter setting,
(e.g. parameter 2)
LRN/SET button 2 x activated
LED blinks 2 x green – parameter 2
OPERATION AND FUNCTIONS:
The receiver is operated with Echo transmitters (radio signal). Before
use, the transmitters must be assigned to the receiver (max. 32
receivers). The receiver‘s Function 1 is preset after assigning a
transmitter to the receiver. It can be changed by function programming.
Every transmitter can control an unlimited number of receivers.
OPERATION WITH ECHO WALL TRANSMITTERS
Function 1 – Two Button Operation
Wall Transmitter
Function
Press button I
Switch on
Press button O
Switch off
Note:
Default function for a transmitter just assigned to the receiver and
also the function for motion sensors!
Function 2: One Button Operation
Wall Transmitter
Function
Press button
Toggle switch state
Parameters
1
Button O is activated
2
Button 1 is activated
3
Button 1 and O are activated
Function 3: Button Control
Wall Transmitter
Function
Press button
Switch on
Release button
Switch off
Parameters
1
Button O is activated
2
Button 1 is activated
3
Button 1 and O are activated
4
Button O is activated, (pulse time 5s)
5
Button 1 is activated, (pulse time 5s)
6
Button 1 and O are activated, (pulse time 5s)
Function 4: Stairwell Light
Wall Transmitter
Function
Press button I or O
Switch on with running time
(parameter)
Parameters
1
2 min running time
2
1 min running time
3
5 min running time
4
10 min running time
5
20 min running time
6
30 min running time
7
60 min running time
8
120 min running time
Note:
Following the preset running time, the light will be switched off for
2s (switch-off warning) and then switched on again for another 30s
