39
MK-101-24
TROUBLESHOOTING
Blade Stops Turning
(A)
Allow motor to cool and de-
press motor Overload Reset
Switch
(B)
Verify all plugs fully installed.
Check Ground Fault Circuit
Interrupter
Verify circuit breaker at least 20 amps - if not, move to 20-amp circuit.
Verify circuit breaker not tripped. If tripped, reset once.
Check power source voltage is 120V - if not 120V, move to another circuit.
NOTE:
If alignment problems are the result of a warped blade, a bent frame or bent support
arm, or, if alignment is off by more than 1/8-inch, contact the MK Diamond Service
Center – (800) 474-5594
(A)
Combination square (square)
12-inch or greater. 1/2-inch
Wrench or MK Triple Hole Box
Wrench and MK Open
End Wrench.
Blade Alignment Procedure
Tools Needed
The Movable Cutting Table of the MK-101-24 may become misaligned with the Cutting Head of the
Tile Saw over time. Should misalignment occur, perform the following steps to realign the Tile Saw.
NOTE:
