Blade 3 – User Manual
MIXTILE
- 10 -
V1.0
Copyright
©
2022 MIXTILE.
1.5.9
LEDs and Dip Switch
The power LED indicate the status of the power supply. There is one SPST four-position dip switch
that can be used to determine the system booting mode of the Blade 3 board. Only one position
can be turned to ON at a time; please keep in mind that you cannot switch two positions to ON at
the same time.
When position 1 is set to ON, the Blade 3 will boot from eMMC.
When position 2 is set to ON, the Blade 3 will boot from the MicroSD card.
When position 3 is turned ON, the Blade 3 will boot from SPI Flash.
When position 4 is activated, Blade 3 enters MaskROM mode for firmware development.
