Mitsubishi NZ2GFCF-D62PD2, User Manual

Page: 265 / 304

263
APPENDICES
A
Appendix 2 Details of R
emote Registers
(9) Remote registers (RWw10 to RWw13, RWw28 to RWw2B)
(10)Remote registers (RWw14 to RWw15, RWw2C to RWw2D)
Address
(RWw)
Item Description Default
CH1 CH2
10
11 28
29 Ring counter lower
limit value
• When the ring counter function is selected and CH  Counter format (address:
0124
H
, 0144
H
) is set to Ring Counter (1), set the count range.
• Set the ring counter upper limit value as well.
• The following shows the setting range.
-2147483648 to 2147483647
• The reflection timing of the setting value
1) When Initial data processing request flag (RX8) turns off
2) When Initial data setting request flag (RY9) is turned off then on (only while
Initial data processing request flag (RX8) is off)
3) When CH  Count enable command (RY24, RY3C) is turned off then on
0
12
13 2A
2B Ring counter upper
limit value
• When the ring counter function is selected and CH  Counter format (address:
0124
H
, 0144
H
) is set to Ring Counter (1), set the count range.
• Set the ring counter lower limit value as well.
• The following shows the setting range.
-2147483648 to 2147483647
• The reflection timing of the setting value
1) When Initial data processing request flag (RX8) turns off
2) When Initial data setting request flag (RY9) is turned off then on (only while
Initial data processing request flag (RX8) is off)
3) When CH

Count enable command (RY24, RY3C) is turned off then on
0
Address
(RWw)
Item Description Default
CH1 CH2
14
15 2C
2D
Preset value setting
• Set a count value to be replaced with the preset value for either of the
preset/replace (at coincidence output) function, the preset/replace function,
the count disable/preset/replace function, or the latch counter/preset/replace
function.
• The following shows the setting range.
-2147483648 to 2147483647
• The reflection timing of the setting value
1) When Initial data processing request flag (RX8) turns off
2) When Initial data setting request flag (RY9) is turned off then on (only while
Initial data processing request flag (RX8) is off)
3) While Initial data processing request flag (RX8) and Initial data setting
request flag (RY9) are off
0