Mitsubishi GOT2000Series, Connection Manual

Page: 110 / 338

5 - 10
5. CONNECTION TO FUJI TEMPERATURE CONTROLLER
5.3 Connection Diagram
(5) RS-485 connection diagram 5)
*1 Pin No. of temperature controller differs depending on the model. Refer to the following table.
*2 Terminating resistor should be provided for a temperature controller which will be a terminal.
*3 Set the terminating resistor of GOT side which will be a terminal.
■
Connecting terminating resistors
*4 Connect FG grounding to the appropriate part of a cable shield line.
(6) RS-485 connection diagram 6)
*1 Pin No. of temperature controller differs depending on the model. Refer to the following table.
*2 Terminating resistor should be provided for a temperature controller and an interface converter which will be terminals.
*3 Connect FG grounding to the appropriate part of a cable shield line.
Signal name
Model of temperature controller
PXR3 PXR4 PXR5/9 PXG4 PXG5/9 PXH9
Pin No. Pin No. Pin No. Pin No. Pin No. Pin No.
+ 15 7 1 7 1 14
- 14 8 2 8 2 16
GOT side
*3
SDA1
SDB1
RDA1
RDB1
SDA2
SDB2
RDA2
RDB2
SG
FG
1
2
3
4
5
6
7
8
9
10
+*
1
-*
1
+*1
-*1
*4
*4
Temperature
controller side Temperature
controller side
Terminating resistor(100Ω 1/2W)
*2
Signal name
Model of temperature controller
PXR3 PXR4 PXR5/9 PXG4 PXG5/9 PXH9
Pin No. Pin No. Pin No. Pin No. Pin No. Pin No.
+ 15 7 1 7 1 14
- 14 8 2 8 2 16
Interface
converter
(K3SC-10)
*2
+
*1
-
*1
+*
1
-*
1
+
-
11
8
*3 *3
Temperature
controller side Temperature
controller side
Terminating resistor(100Ω 1/2W)
*2