Mitsubishi GOT1000 GT11, User Manual

Page: 47 / 256

5 - 1
5.1 Requirements for Conformance to EMC Directive
5.1.1 Standards applicable to the EMC Directive
1
OV
E
R
VI
EW
2
SYSTE
M
CO
N
F
IG
UR
A
T
IO
N
3
S
P
E
CI
F
ICA
T
ION
S
4
PA
R
T
N
A
M
E
5
EMC DIRECTIVE
6
INS
TAL
L
A
TI
ON
7
WIRING
8
OP
TIO
N
5. EMC DIRECTIVE
For the products sold in European countries, the conformance to the EMC Directive, which is one of the
European Directives, has been a legal obligation since 1996. Also, conformance to the Low Voltage
Directive, another European Directives, has been a legal obligation since 1997.
Manufacturers who recognize their products must conform to the EMC and Low Voltage Directives required
to declare that their products conform to these Directives and put a "CE mark" on their products.
Products that the EMC Directive applies to are marked with the CE mark logo.
5.1 Requirements for Conformance to EMC Directive
The EMC Directive specifies that products placed on the market must "be so constructed that they do not
cause excessive electromagnetic interference (emissions) and are not unduly affected by electromagnetic
interference (immunity)".
The applicable products are requested to meet these requirements.
The sections 5.1.1 through 5.3.2 summarize the precautions on conformance to the EMC Directive of the
machinery constructed using the GOT.
The details of these precautions has been prepared based on the requirements and the applicable standards
control. However, we will not assure that the overall machinery manufactured according to these details
conforms to the above-mentioned directives. The method of conformance to the EMC Directive and the
judgment on whether or not the machinery conforms to the EMC Directive must be determined finally by the
manufacturer of the machinery.
5.1.1 Standards applicable to the EMC Directive
The following products have shown compliance through direct testing (to the identified standards) and
design analysis (forming a technical construction file) to the European Directive for Electromagnetic
Compatibility (89/336/EEC) when used as directed by the appropriate documentation
Type : Programmable Controller (Open Type Equipment)
Models : MELSEC GOT series products, identified here, manufactured from April 1st, 2005
GT1155-QSBD and GT1150-QLBD (For this product see note under and over the page).
Standard Remark
EN61131-2 : 2003
Programmable controllers
- Equipment, requirement and tests
EMI
Compliance with all relevant aspects of the standard.
(Radiated Emissions)
EMS
Compliance with all relevant aspects of the standard.
(ESD,RF electromagnetic field, EFTB, Surge, RF conducted
disturbances and Power frequency magnetic field)