Mitsubishi ECLIPSE CROSS 2017, Owner'S Manual

Page: 42 / 538

Warning activation
E00305902187
In order to prevent vehicle theft or the accidental operation of the keyless operation system, the buzzer and the display on the information screen
in the multi-information display are used to alert the driver.
If a warning is activated, always check the vehicle and the keyless operation key. The warning is also displayed if there is a fault in the keyless
operation system.
Item Display Buzzer Note (Solution)
Detection of failure Inner buzzer sounds
once There is a fault in the keyless operation system.
Fall of battery voltage Inner buzzer sounds
once The battery starts to run out, the warning is activated. (The
warning is not activated if the battery is completely dead.)
Key not detected
Engine switch is pressed
one time
Inner buzzer sounds once When the engine switch is pressed to change the operation mode
from OFF or when the engine is started, the warning is activated,
if any of the following conditions has occurred.
l Carrying another keyless operation key with a different code,
or the keyless operation key could be outside the operating
range.
l The battery of the keyless operation key is dead.
l Communication is blocked by electric wave environment.
In such case, touch the keyless operation key to the engine switch
to change the operation mode or start the engine.
Refer to “If the keyless operation key is not operating properly”
on page 6-23.
Engine switch is pressed
two times or more
Keyless operation system*
3-14
OGKE18E1
Locking and unlocking
3