Mitsubishi ECLIPSE CROSS 2017, Owner'S Manual

Page: 116 / 538

l When the engine switch or the operation
mode is in the following conditions, the
average fuel consumption display and
average speed display are automatically
reset.
[Except for vehicles equipped with key-
less operation system]
The ignition switch is in the “ACC” or
“LOCK” position for approximately 4
hours or longer.
[For vehicles equipped with keyless op-
eration system]
The operation mode is in ACC or OFF
for approximately 4 hours or longer.
NOTE
l The average fuel consumption display and
average speed display can be reset separately
for the auto reset mode and for the manual
reset mode.
l The memory of the auto reset mode or man-
ual reset mode for the average fuel con-
sumption display and average speed display
is erased if the battery is disconnected.
Changing the fuel consumption
display unit
E00523001912
The display unit for fuel consumption can be
switched. The distance, speed, and amount
units are also switched to match the selected
fuel consumption unit.
1. Switch to the function setting screen.
Refer to “Changing the function set-
tings” on page 5-13.
2. Press the switch or switch several
times to switch to the “FUEL CON-
SUMPTION UNIT” screen. Then, press
the switch to switch to the setting se-
lection screen.
3. Press the switch or switch to select
the units, and then press the switch to
confirm the setting.
The setting is changed to the selected
unit.
NOTE
l
The display units for the driving range, the
average fuel consumption, the average speed
and the instant fuel consumption are switch-
ed, but the units for the indicating needle
(speedometer), the odometer and the tripme-
ter will remain unchanged.
The distance and speed units are also switch-
ed in the following combinations to match
the selected fuel consumption unit.
Fuel con-
sumption Distance
(driving
range)
Speed
(average
speed)
km/L km km/h
L/100 km km km/h
mpg (US) mile(s) mph
mpg (UK) mile(s) mph
Changing the temperature unit
E00523101939
The display unit for temperature can be
switched.
1. Switch to the function setting screen.
Refer to “Changing the function set-
tings” on page 5-13.
2. Press the switch or switch several
times to switch to the “TEMPERA-
TURE UNIT” screen.
Multi-information display
5-16
OGKE18E1
Instruments and controls
5