Mitsubishi ECLIPSE CROSS 2017, Owner'S Manual

Page: 110 / 538

1. When you press the switch or
switch a few times, the information
screen switches to the service reminder
display screen.
2. Press and hold the switch for about 2
seconds or more to display “ ” and
make it flash. (If there is no operation
for about 10 seconds with flashing, the
display returns to the previous screen.)
3. Press the switch while the icon is
flashing to change the display from “---”
to “CLEAR”. After this, the time until
the next periodic inspection will be dis-
played.
CAUTION
l
The customer is responsible for making sure
that periodic inspection and maintenance are
performed.
Inspections and maintenance must be per-
formed to prevent accidents and malfunc-
tions.
NOTE
l “---” display cannot be reset when the igni-
tion switch or the operation mode is in ON.
l When “---” is displayed, after a certain dis-
tance and a certain period of time, the dis-
play is reset and the time until the next peri-
odic inspection is displayed.
l If you accidentally reset the display, we rec-
ommend you to consult a MITSUBISHI
MOTORS Authorized Service Point.
System check screen
E00531001197
When the ignition switch is turned to the
“ON” position or the operation mode is put in
ON, the system check screen is displayed for
approximately 4 seconds. If there is no fault,
information screen (when the ignition switch
or the operation mode is ON) is displayed.
If there is a fault, the screen changes to warn-
ing display.
Refer to “Warning display list” on page
5-24.
Driving range display
E00538000027
This displays the approximate driving range
(how many more kilometres or miles you can
drive). When the driving range falls below
approximately 50 km (30 miles), “---” is dis-
played.
Refuel as soon as possible.
NOTE
l
The driving range is determined based on
the fuel consumption data. This may vary
depending on the driving conditions and
habits. Treat the distance displayed as just a
rough guideline.
l When you refuel, the driving range display
is updated.
However, if you only add a small amount of
fuel, the correct value will not be displayed.
Fill with a full tank whenever possible.
Multi-information display
5-10
OGKE18E1
Instruments and controls
5