Mitsubishi 2015 OUTLANDER, Owner'S Manual

Page: 288 / 490

3. The warning lamp start flashing slowly.
4. Drive for a while. The reset is completed
if the warning lamp goes out.
NOTE
l The reset function should be executed every
time when the tyre pressure or tyre rotation
is adjusted.
l The reset function should be executed when
the tyre is cold. If it is executed when the
tyre is warm (e.g. after driving), there may
be a low tyre pressure warning earlier than
usual.
Tyre ID set change
E00637600043
In case that 2 sets of tyre inflation pressure
sensor ID are registered in the receiver, the
valid tyre ID set can be changed by following
procedure.
[For vehicles equipped with colour liquid
crystal display meter]
1. Operate the multi-information display
switch to switch the information screen
to the menu screen.
Refer to “Multi information display
switch” on page 5-05
Refer to “Changing the function set-
tings” on page 5-14
2. Lightly press the multi-information dis-
play switch to select “ ” (tyre
ID set change).
3. Hold down the multi-information dis-
play switch for about 3 seconds or more.
The setting changes the selected tyre ID
set.
4. The valid tyre ID set is changed, and the
number of the tyre pressure monitoring
system (TPMS) SET indicator is
changed.
NOTE
l Each time this procedure is done, the tyre ID
set is changed. (1 - 2 - 1 - 2 …)
l The tyre ID set is NOT changed, in case that
only 1 set of ID is registered.
NOTE
l When changing the tyre ID set, the reset
function of low tyre pressure warning
threshold is automatically started. (The
warning lamp start flashing slowly.) If the
tyre is warm at this time. the reset function
should be executed again when the tyre is
cold.
[For vehicles equipped with mono-colour liq-
uid crystal display meter]
1. Transit the display by multi-information
display switch until the tyre pressure
monitoring system (TPMS) SET indica-
tor is displayed.
Tyre pressure monitoring system (TPMS)*
6-106
OGFE16E1
Starting and driving
6