Mitsubishi MOTORS Mirage 2012, Owner'S Manual

Page: 147 / 250

2. If the radio detects traffic information on ei-
ther the station currently selected or another
station, the display will show “TRAF INF”
for 5 seconds followed by a 2-second indica-
tion of the frequency. Then, it will show the
name of the station broadcasting the traffic in-
formation to which you will listen. The vol-
ume level is set separately for listening to nor-
mal audio programs and for listening to traf-
fic information. The volume level will there-
fore change automatically to that set when
traffic information was last received. When
the traffic information broadcast is over, the
radio will return to the previously received
program and to the corresponding volume lev-
el.
3. Press the TP button to return to the previous
condition.
NOTE
l While “TP” is illuminated, the radio stops on-
ly at TP stations, even if the SEEK button is
pressed.
TP (Traffic information Program) search function
E00721800197
The traffic information program standby function
is turned on (with the TP indicator shown on the dis-
play) and after about 45 seconds since the RDS in-
dicator turns off due to weak signal or the tuning
station is changed over from a TP station to a sta-
tion which does not broadcast traffic information,
the sound will beep 5 times and seeks out a TP sta-
tion in all frequencies automatically.
The TP search function can be turned ON and OFF.
Refer to “Function setup mode” on page 5-17.
Emergency broadcasts
E00721700268
If an emergency broadcast is caught while receiv-
ing a FM broadcast or playing back a compact disc
with the ignition switch or the operation mode is in
ON or ACC, the display will show “ALARM” and
the emergency broadcast will interrupt the current
program. The volume level is set separately for lis-
tening to normal audio programs and for listening
to emergency broadcasts. The volume level will
therefore change automatically to that set when an
emergency broadcast or traffic information broad-
cast was last received. When the emergency broad-
cast is over, the radio will return to the previously
received program and to the corresponding volume
level.
Function setup mode
E00722500465
It is possible to change the following functions:
l AF
l REG*
l TP-S
l PI-S*
l Language of PTY display
1. Press the /MENU button for 2 seconds or
longer to select the function setup mode.
2. Press the SEEK button repeatedly to select
the mode you wish to change.
The order is: AF → REG* → TP-S → PI-S*
→ Language of PTY display → Function set-
up mode OFF.
3. Select the desired setting for each mode to be
turned ON and OFF as shown below.
The setting will be shown on the display.
Example
NOTE
l After selecting a mode, you can leave the func-
tion setup mode by taking either of the fol-
lowing steps:
• Press the /MENU button for at least 2
seconds.
• Make no entry for 10 seconds.
CD control panel and display
E00709501263
For pleasant driving
5-17
OA0X13E4
5