Mitsubishi MOTORS L200 1996, Workshop Manual

Page: 1418 / 1723

SRS –
Post-collision Diagnosis/Individual Component Service
52B-21
Air bag module
1. Check pad cover for dents, cracks or deformation.
2. Check connector for damage, terminals deformities, and
harness for binds.
3. Check air bag inflator case for dents, cracks or deformities.
4. Install air bag module to steering wheel to check fit or
alignment with the wheel.
Clock spring
1. Check clock spring connectors and protective tube for
damage, and terminals for deformation.
2. Visually check the case for damage.
Steering wheel, steering column and intermediate joint
1. Check wiring harness (built into steering wheel) and
connectors for damage, and terminals for deformation.
2. Install air bag module to check fit or alignment with steering
wheel.
3. Check steering wheel for noise, binds or difficult operation
and excessive free play.
Harness connector (body and front wiring harness)
Check harnesses for binding, connectors for damage, poor
connection, and terminals for deformation. (Refer to P.
52B-18.)
INDIVIDUAL COMPONENT SERVICE
52400290148
If the SRS components are to be removed or replaced as a result of maintenance, troubleshooting,
etc., follow each procedure (P.52B-23 – P.52B-33.)
Caution
1.
SRS components should not be subjected to heat over 93
_
C, so remove the SRS diagnosis
unit, air bag module, clock spring and front impact sensors before drying or baking the vehicle
after painting.
2. If the SRS components are removed for the purpose of check, sheet metal repair, painting,
etc., they should be stored in a clean, dry place until they are reinstalled.
Inflator case
Connector
Case
Protective tube
Protective tube