Mitsubishi MOTORS Eclipse Cross 2019, Owner'S Manual, Page: 173 / 602

NOTE
l
The AHB recognises environmental condi-
tions by sensing a light source ahead of your
vehicle. Therefore, you may feel like some-
thing is not quite right when the headlamp
beams are switched automatically.
l The system may not detect a light vehicle
such as a bicycle.
l The system may not detect an ambient
brightness precisely. This causes the traffic
to be dazzled by high-beam or the low beam
to be maintained. In such cases, you should
switch the headlamp beams manually.
• In bad weather (heavy rain, fog, snow or
sandstorm).
• The windscreen is dirty or fogged up.
• The windscreen is cracked or broken.
• The sensor is deformed or dirty.
• A light that is similar to the headlamps or
tail lamps is shining around your vehicle.
• A vehicle in front or oncoming vehicle is
driven without lights, the exterior lamps
are dirty or discoloured, or the direction
of the headlamp beams is adjusted im-
properly.
• It becomes dark and bright suddenly and
continuously around your vehicle.
• Your vehicle is driven on uneven surfaces.
• Your vehicle is driven on a winding road.
• A reflective object such as a noticeboard
or a mirror reflects a light ahead of your
vehicle.
• When lamps of the vehicle in front or
headlamps of an oncoming vehicle blend
into the other lamps.
NOTE
• The rear end of a vehicle in front (such as
a container truck) reflect a strong light.
• Your vehicle’s headlamp is broken or
dirty.
• Your vehicle is inclined due to a flat tyre
or towing.
• The warning display appears.
(Refer to “System problem warning” on
page 5-61.
l Observe the precautions below to maintain
good usage conditions:
• Do not attempt to disassemble the sensor.
•
Do not affix a sticker or label on the
windscreen near the sensor.
• Avoid overload.
• Do not modify your vehicle.
• When the windscreen is replaced, use the
MITSUBISHI MOTORS GENUINE
parts.
System problem warning
If a problem occurs with the system, the fol-
lowing warning display will appear to the
type of the problem.
The AHB deactivation due to fault
If a failure is detected in the system, the fol-
lowing warning display will appear and the
AHB will automatically be turned off.
If the warning display remains even after the
ignition switch is turned to the “LOCK” posi-
tion or the operation mode is put in OFF and
then turned back to ON, please contact a
MITSUBISHI MOTORS Authorized Service
Point.
[When the AHB is malfunctioning]
[When the sensor is malfunctioning]
NOTE
l If the sensor or its surrounding area reaches
an extremely high temperature when parking
the vehicle under a blazing sun, the “AHB
SERVICE REQUIRED” warning display
may appear.
If the warning display remains even after the
temperature of the sensor or its surrounding
area has been in range, please contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
Combination headlamps and dipper switch
5-61
OGKE20E1
Instruments and controls
5