Downloaded from Projector.com
E-47
Lamp Mode
Use this if the picture is projected on a small screen and the picture is
too bright or when projecting images in dark rooms.
Select the item name “Lamp Mode” and select the setting contents with the
SELECT
왗왘
buttons.
Low ............ The lamp brightness is set to 80% and the lamp life is extended.
(STATUS indicator is green)
Normal ....... The lamp brightness is set to 100% and the screen is bright.
(STATUS indicator is off)
Note:
Frequent switching this mode can degrade the lamp.
Setup
Input Format
This function is used in setting the input signals of the input connec-
tors.
Normally, this should be set to Auto. When identification is not possible
with Auto, make the setting.
Select the item name “Input Format”, press the ENTER button, and the sub
menu will open.
Select the connector that is to be changed, and select the setting contents
with the SELECT
왗왘
buttons.
[PC]
This is the signal setting for the DVI connector.
Auto ............ Automatically identifies the signal.
RGB ............ Analog RGB signal is set.
Digital ......... Digital RGB signal is set.
Component . Component signal is set.
(YPbPr and YCbCr signals are identified automatically.)
[Video] and [SVideo]
[Video] is the color system setting for the VIDEO connector and [SVideo] is
the color system setting for the S-VIDEO connector.
Auto ............ Automatic identification.
NTSC .......... Fixed to the NTSC system.
PAL ............. Fixed to the PAL system.
SECAM ....... Fixed to the SECAM system.
STATUS
STANDBY
STATUS Indicator
