Mitsubishi Electric SUZ-KA09NA2.MX, Service Manual

Page: 31 / 36

31
OCH699
F1 F2 F3 F4
u n e m e c i v r e S
r o s r u C
: u n e m n i a M
Test run
Input maintenance info.
Function setting
Check
Self check
F1 F2 F3 F4
Function setting
Cursor Address
Monitor:
Ref. address
Unit No.
Grp. /1/2/3/4/All
Function setting
Cursor Cursor
Request:
Ref. address
Mode 1
Mode 2
Mode 3
Mode 4
Grp.
F1 F2 F3 F4
Function setting
Cursor Cursor
Request:
Ref. address
Mode 7
Mode 8
Mode 9
Mode 10 Unit #1
2
Set the indoor unit refrigerant addresses and unit numbers with the F1
through F4 buttons, and then press the button to confirm the current
setting.
Select "Function setting" with the F1 or F2 button, and press the button.
3
When data collection from the indoor units is completed, the current settings
appears highlighted.
Non-highlighted items indicate that no function settings are made.
Screen appearance varies depending on the "Unit No." setting.
4
Use the F1 or F2 button to move the cursor to select the mode number,
and change the setting number with the F3 or F4 button.
1
Select "Service" from the Main menu, and press the button.
<Checking the indoor unit No.>
When the button is pressed, the target indoor unit will start fan operation.
If the unit is common or when running all units, all indoor units for the selected
refrigerant address will start fan operation.
F1 F2 F3 F4
Function setting
Ref. address
Sending data
Grp.
5
When the settings are completed, press the button to send the setting
data from the remote controller to the indoor units.
When the transmission is successfully completed, the screen will return to the
Function setting screen.
Note: • Make the above settings only on Mr. Slim units as necessary.
• The above function settings are not available for the CITY MULTI
units.
• Table 1 summarizes the setting options for each mode number. Refer to
the indoor unit Installation Manual for the detailed information about ini-
tial settings, mode numbers, and setting numbers for the indoor units.
• Be sure to write down the settings for all functions if any of the initial
settings has been changed after the completion of installation work.
<Function setting>