5-73
Maintenance and inspection procedures
5Maintenance and Inspection
5.3.3 Packing Replacement Procedure
When signs of cracking or peeling are noted in the packing, they must be replaced.Replace the packing in
accordance with the instructions given below. If the packing is not replaced in a timely manner, water or oil will be
allowed to intrude the robot, possibly making it inoperative.
(1) Packing Replacement Instructions
Stick again new packing as before.
1) Remove the old packing, and clean and degrease the surface on which it has been placed.
2) The sticking surface of packing is double-coated adhesive tape. Referring to
"Fig.5-4 ： Example of sticking
"Fig.5-6 ： Sticking the cord-like packing"
, and stick the packing in line with
form . Be careful for the packing not to slide. The example of unsuitable packing slid is shown in
5 ： Example of sticking packing (bad example)"
.
3) Although the No.2 arm cover (U) sticks two or more packings per place, it has length with which packing
ends overlap. Stick packing in the following procedures. For more information, see
Examples of improperly treated cut edge are shown, as well.
a) Stick packing in line with form of the sticking surface. Finally, cut packing so that adjoining pieces have
a 1mm overlap at the end.
b) Apply liquid gasket to the cut edges. (Designated liquid gasket: 1212 (Maker: Three Bond))
c) Stick so that the gap may not be made to each other's packing.
Do not install the cover immediately after sticking packing. Install the cover,
after the 6 hours pass after sticking packing for gasket hardening.
4) Confirm that packing is stuck correctly and install the cover. When tightening the bolts fixing the cover,
avoid tightening them to a specified torque at a time. Tighten the bolt in the order shown as much as
possible in the
"Fig. 5-8 Example of order which tighten bolts"
The torque which tightens the fixing bolt of
each cover is shown in
"Table 5-3 ： Cover fixing screw list"
.
Stick the packing securely, pressing down with the finger. If sticking is insuffi
-
cient, when the cover is installed, packing slides by the pressure, and there is a
possibility that it may become impossible to secure protection performance.
Completion of packing replacement
Fig.5-4 ： Example of sticking packing (good example)
CAUTION
CAUTION
Packing is stuck securely
without sliding.
