Mitsubishi Electric NZ2GF2B-60TCRT4, User Manual

Page: 295 / 388

293
APPENDICES
A
Appendix
1 Det
ails of
Rem
ot
e I
/O
S
ignals
Appendix
1.
1 Rem
ot
e
input
signals
(14)CH  Sensor two-point correction offset latch completion flag (RX28, RX2A,
RX2C, RX2E)
When a sensor two-point correction offset value is stored in a remote buffer memory area, this signal turns to
Latch completed (ON).
When CH
 Sensor two-point correction offset latch request (RY28, RY2A, RY2C, RY2E) is turned to No request
(OFF), the signal turns to No request (OFF). (

Page 300, Appendix 1.2 (9))
For details on the sensor two-point correction function, refer to the following.

Page 133, Section 8.1.5 (2)
(15)CH

Sensor two-point correction gain latch completion flag (RX29, RX2B,
RX2D, RX2F)
When a sensor two-point correction gain value is stored in a remote buffer memory area, this signal turns to
Latch completed (ON).
When CH
 Sensor two-point correction gain latch request (RY29, RY2B, RY2D, RY2F) is turned to No request
(OFF), the signal turns to No request (OFF). (

Page 300, Appendix 1.2 (10))
For details on the sensor two-point correction function, refer to the following.

Page 133, Section 8.1.5 (2)
(16)CH  Transistor output flag (RX30, RX32, RX34, RX36) , CH  Heating
transistor output flag (RX30, RX32, RX34, RX36) , CH

ON delay output
flag (RX31, RX33, RX35, RX37) , CH  Heating ON delay output flag (RX31,
RX33, RX35, RX37) , CH  Cooling transistor output flag (RX38, RX3A,
RX3C, RX3E) , CH  Cooling ON delay output flag (RX39, RX3B, RX3D,
RX3F)
ON/OFF status of transistor output and ON delay output are stored in these signals. In the heating-cooling
control, ON/OFF status of transistor output/ON delay output for heating are stored in RX38 to RX3F.
Common
Common
Standard
Heating-cooling
Standard
Heating-cooling
Heating-cooling
Heating-cooling