- 6 -
[ Figure 6 – Layout of Switches ]
2.3 Setting Network Dome Camera Termination
The device which is connected at end of line, whether it be a Network Dome Camera or
keyboard controller, must have the cable for communication terminated by setting the
appropriate DIP switch. Without proper termination, there is potential for control signal errors.
Total length of the cable for communication should not exceed 1.2km.
ON
KSD02H
1 2
9A
SW1
[ Figure 7 – Setting Network Dome Camera Termination ]
2.4 Setting Network Dome Camera Address (ID)
To prevent damage, each Network Dome Camera must have a unique address (ID). When
installing multiple Network Dome Cameras using a multiplexer, it is suggested that the
Network Dome Camera address match the multiplexer port number.
If you want to set the address more than 999, you should contact the service provider.
Refer to „3.3.4 PTZ Setting‟
se
ction for detailed information.
2.5 Setting Network Dome Camera Protocol
If a Network Dome Camera is to be installed with a Fastrax keyboard controller, select F2
protocol.
Consult service personnel if a Network Dome Camera is installed with device other than a
keyboard controller.
Refer to „3.3.4 PTZ Setting‟
se
ction for detailed information.
SW1
1
2
Terminated
ON
ON
Not terminated
OFF
OFF
Summary of Contents for NM-C150SD
Page 1: ......
Page 9: ... 4 Figure 4 Dimension ...
Page 33: ... 28 Chapter 4 Appendix 4 1 Product Specification ...
