En-
I-
SAvE OPERATION
1
Press
during COOL, ECONO COOL, or HEAT
mode to select i-save mode.
2
Set the temperature, fan speed, and airflow direction.
• The same setting is selected from the next time by simply pressing
.
• Two settings can be saved. (One for COOL/ECONO COOL, one for
HEAT)
• Select the appropriate temperature, fan speed, and airflow direction
according to your room.
• Normally, the minimum temperature setting in HEAT mode is 16°C.
However, during i-save operation only, the minimum temperature set-
ting is 10°C.
Press
again to cancel i-save operation.
• i-save operation also is canceled when the MODE or POWERFUL but-
ton is pressed.
i-save operation
• A simplified set back function enables to recall the preferred (preset) setting
with a single push of the
button. Press the button again and you can go
back to the previous setting in an instance.
• i-save operation cannot be set on the weekily timer.
Example of use:
1. Low energy mode
Set the temperature 2°C to 3°C warmer in COOL and cooler in HEAT mode.
This setting is suitable for unoccupied room, and while you are sleeping.
2. Saving frequently used settings
Save your preferred setting for COOL/ECONO COOL and HEAT. This ena-
bles you to select your preferred setting with a single push of the button.
Note:
When using the multi system MXZ-8A140, the temperature cannot be set to
10°C. Even if the temperature is set to 10°C, the air conditioner will operate
at 16°C.
E
CONO COOL OPERATION
Press
during COOL mode
page 4
to start
ECONO COOL operation.
The unit performs swing operation vertically in various cycles according to the
temperature of airflow.
Press
again to cancel ECONO COOL operation.
• ECONO COOL operation is canceled when the vANE, LONG, or
POWERFUL button is pressed.
What is “ECONO COOL”?
Swing airflow (change of air flow) makes you feel cooler than stationary airflow.
The set temperature and the airflow direction is automatically changed by the mi
-
croprocessor. It is possible to perform cooling operation with keeping comfort.As a
result energy can be saved.
1
Press
or
during operation to set the timer.
(ON timer) : The unit turns ON at the set time.
(OFF timer) : The unit turns OFF at the set time.
*
or
blinks.
* Make sure that the current time and day are set correctly.
Page 3
2
Press
(Increase) and
(Decrease) to set the
time of timer.
Each press increases or decreases the set time by 10 minutes.
• Set the timer while
or
is blinking.
3
Press
or
again to cancel timer.
Note:
• ON and OFF timers can be set together. mark indicates the order of timer
operations.
• If power failure occurs while ON/OFF timer is set, see
page 4
“Auto restart
function”.
T
IMER OPERATION (ON/OFF TIMER)
JG79A789H01_en.indd 6
2013/07/18 11:12:48