32
8. REMOVING THE LIQUID PIPE THERMISTOR AND
COND/EVA TEMP. THERMISTOR
(1) Remove the front panel. (Refer to step 2)
(2) Remove the electrical box cover.
(3) Remove the motor band.
(4) Cut the wiring fixed band.
(5) Remove the liquid pipe thermistor and cond/eva temp. ther-
mistor.
(6) Disconnect the connector (CN44) on the indoor
controller
board.
Photo 12
Liquid pipe thermistor (TH2)
Condenser/evaporator temp.
thermistor (TH5)
Heat exchanger
9. REMOVING THE HEAT EXCHANGER
(1) Remove the front panel (Refer to step 2) and the corner
panel at right lower side.
(2) Remove the electrical box (Refer to step 4) and the nozzle
assembly (Refer to step 5).
(3) Remove the motor band.
(4) Remove the pipe thermistors (Refer to step 8).
(5) Disconnect the connector (CN60) on the indoor controller
board and the connector for ground wire. (See Photo 5)
(6) Remove the screws fixing the left side of the heat
exchanger. (See Photo 9)
(7) Remove the heat exchanger.
10. REMOVING THE ROOM TEMPERATURE THERMISTOR
(1) Remove the front panel (Refer to step 2).
(2) Remove the electrical box cover.
(3) Remove the room temperature thermistor.
(4) Disconnect the connector (CN20) on the indoor controller
board.
Photo 13
Photo 14
Electrical box cover (top)
Electrical box cover (side)
Screw (side cover)
Screw (top cover)
Switch board cover
Holder of
IR wireless
controller board
Nozzle assembly
Water cover
Screw
(side
cover)
Heat exchanger
Electrical box
cover (top)
Electrical box
cover (side)
Screw (side cover)
Screw
(side cover)
Switch holder
Nozzle assembly
Screw (top cover)
Room temp.
thermistor
(TH1)
Thermistor
holder
Holder of
IR wireless
controller board
PHOTOS
OPERATION PROCEDURE
