40
Door adjustment
1
If the adjustment bolt is not in contact with the floor, lower the bolt, and adjust it so that the caster is slightly above the floor.
2
When the refrigerator is installed in the corner of the room, the bolt of the refrigerator may sink into the floor and cause the
refrigerator to tilt. It is recommended to make adjustments by objects like boards beforehand.
3
When the refrigerator bolt is sunk into the floor, and it can be confirmed visually, prevent sinking by using objects like
boards.
<Adjusting refrigerator compartment doors>
• Common elements
First, check the installation condition.
Note : The refrigerator weighs about 100kg, and is held by four bolts. How far each bolt sinks into the floor depends on
factors such as floor pillars. Change in balance due to position of stored food (such as large or small amount of food
stored in the door pockets) may also affect sinking.
Problem
Solution
Adjusting doors horizontally
B
A
A
B
A
B
Adjusting vertical space between doors
Too much space
Not enough space
A>B (More space in outer side)
1
Or
A<B (More space in inner side)
A>B (Too much space between
the ice making compartment and
versa compartment doors.)
Misaligned versa compartment
door
3
Misaligned ice making
compartment door
4
A<B (Small space between the ice
making compartment and versa
compartment doors.)Misaligned
versa compartment door
5
Misaligned ice making
compartment door
6
1
Place spacer set under the
outer roller of the tilted door
(ice making compartment door
in the above illustration) to
adjust position.
2
Place spacer
set under the inner roller of the
tilted door
(ice making compartment door
in the above illustration) to
adjust position.
3
Replace roller set of the right
and left versa compartment
doors.
a To adjust about 0.5mm
Replace with roller set C.
b To make large adjustment
Replace with roller set D.
4
Replace lower roller set of the
ice making compartment door.
c To adjust about 0.5mm
Replace with roller set A.
d To make large adjustment
Replace with roller set B.
3
Place roller set of the right and
left versa compartment doors.
a To adjust about 0.5mm
Replace with roller set A.
b To make large adjustment
Replace with roller set B.
6
Replace lower roller set of the
ice making compartment door.
c To adjust about 0.5mm
Replace with roller set C.
d To make large adjustment
Replace with roller set D.
<Adjusting ice making compartment and versa compartment doors>
right 0.5 [09]
right 1.0 [11]
left 0.5 [13]
left 1.0 [15]
Marking
LH
RH
I dentifying roller sets (Marking)
right 0.5 [10]
right 1.0 [12]
left 0.5 [14]
left 1.0 [16]
Marking
LH
RH
Roller set A (0.5mm to the right)
Roller set B (0.5mm to the right)
Roller set C (0.5mm to the right)
Roller set D (0.5mm to the right)
09
11
13
15
10
12
14
16
OA090-2.qxp 06.7.20 9:57 AM Page 40
Summary of Contents for MR-G50J-SS-NZ
Page 47: ...47 ...
