- 5 -
2-4. Installing Solenoid valve
(1) Pull up the adjustment handle of the Filter regulator <1> located under the table, and
Turn counterclockwise until the pressure gauge shows 0.
(2) Remove five screws <3>, and motor cover <2>.
(3) Remove two screws <6> from Solenoid valve <4>, and blanking plate assy.
Note If two or more blanking plate assy are attached, please remove any one.
(4) Install the solenoid valve through gasket with two screws as shown in the figure, where the blanking
plate assy <5> was removed (2).
Insert the plug (Fig.No.124) completely the hole on the left side of the solenoid valve.
123
124
<2>
<3>
<5>
<6>
<4>
<1>
Summary of Contents for MP-J25-AD
Page 2: ......
Page 16: ...Printed in Japan ...