8.2.5
AT+T Send - Sending SMS, E-Mail, Fax and Express E-Mail Messages
Setting General Message Parameters
Sending a Fax
AT Commands MIM-A01
Appendix
8 - 14
MITSUBISHI ELECTRIC
AT+T Send="All;..."
AT+T Send="ALL; DialPrefix:nnn; ModemName:Name; ModemNumber:number End:char"
This command sets the parameters that are common to all types of messages;
no message is sent.
No message text can be entered after this command!
nnn:
Getting an Outside Line Prefix
If you are using the modem on a system where a prefix is needed to get an outside line, en-
ter it here. Enter characters which can be dialled (0-9,*,#, comma) only.
If no prefix is needed to get an outside line, you can leave out this parameter.
Name:
When sending fax messages, this name is used in the header of the
fax sent and as sender ID when sending Express E-Mails.
A maximum of 16 alphanumeric characters is allowed.
Number:
Number of the telephone line to which your Tixi modem is connected.
This number must be entered in international format: +49-30-1234567.
This number is used in the headers of fax messages and is listed as the sender for Express
E-Mails.
Char:
Defines the character that closes the message and starts sending. (default:
<STRG>+<Z>)
Example:
Enter the external call prefix "0", the modem name "John Doe Inc, modem 2" and
the telephone number "+44-20-1234567":
AT+T Send = "All; DialPrefix:0; ModemName: John Doe Inc, modem 2;
ModemNumber: +44-20-1234567"
AT+T Send="Fax;..."
AT+T Send="Fax; Dial: number"
>SubjectText
>MessageText line#1
>MessageText line#n
><CTRL>+<Z>
This command sends a text message as fax or sets the parameters.
When you have closed the command line with <CR/LF>, the modem displays a prompt (>) where
you can specify the subject line you want in your fax message. The message text is entered in sub-
sequent lines. To close this message, press the keys <CTRL>+<Z>.
If you skip the message text, the parameters are saved for later use until replaced by new parameters.
Number:
The recipients fax number.
Enter characters which can be dialled (0-9,*,#, comma) only.
SubjectText:
This is the first line of the message text. It forms the subject line
of the fax message.
MessageText line#1...n:
Other lines of the message text.
Each line is entered at the prompt character displayed by the mo-
dem and closed by <CR/LF>. During sending the modem does
an automatic line break after 75 characters by itself. The messa-
ge text must not contain umlauts.
Example:
AT+T Send="Fax; Dial: 40578747"
>Hello Paul
>This is the important message sent by fax.
>
>See you.
><CTRL>+<Z>
Short modem reply:
OK
Summary of Contents for MIM-A01
