20
6. Battery Installation and Replacement
6.1 Installing battery
This product is shipped with the battery connector removed. Before use, make sure to connect the battery connector.
(1) Open the battery cover on the bottom of the product.
(2) Check that battery is properly installed.
(3) Insert the connector on the battery into the
case side connector pin in the right direction.
6.2 Replacing battery
When the battery reaches its end of life,
the “ERR.” LED on the server section lights red. Replace the battery with a
new one. (
See “11. Options” of this instruction manual.)
(1) Open the front cover on the server section, and hold the
RESET/SELECT switch to the SEL position.
(2)
When the “CF CARD” LED goes out, turn this product off.
(3) Open the battery cover on the bottom of the server section.
(4) Remove the battery from the holder.
(5) Insert a new battery into the holder in the right direction
and connect the lead connector to the connector.
(6) Close the battery cover.
(7) Turn this product on.
Caution
Make sure to perform battery replacement with electricity off.
Perform battery replacement within 3 minutes. If 3 minutes passes with the battery
removed, the data for the last 1 hour and the clock setting may be initialized. (The data and
setting values older than those for the last 1 hour are not initialized.)
If the IP address and clock settings are initialized, reconfigure those settings after backing
up the data.
Connector
(main unit side)
Connector
(battery side)
AA
Make bundles of excess lengths of lead wire on the top of the battery
(inside the main unit) as shown below.
Connector
Connector fastener
Battery lead wire
Battery
Summary of Contents for MES3-255C-EN
Page 39: ...39 MEMO ...
Page 40: ...40 MEMO ...
