Mitsubishi Electric MELSERVO-J4 series, Instruction Manual

Page: 231 / 646

6 NORMAL GAIN ADJUSTMENT
6.2 One-touch tuning
229
6
6.2
One-touch tuning
• When executing the one-touch tuning, check the [Pr. PA21 One-touch tuning function selection] is "_ _ _ 1"
(initial value).
• Refer to the following for one-touch tuning via a network.

Page 235 One-touch tuning via a network
Connect MR Configurator2 and open the one-touch tuning window, and you can use the function. The following parameters
are set automatically with one-touch tuning.
Parameter Symbol Name
PA08 ATU Auto tuning mode
PA09 RSP Auto tuning response
PB01 FILT Adaptive tuning mode (adaptive filter  )
PB02 VRFT Vibration suppression control tuning mode (advanced vibration suppression control

)
PB06 GD2 Load to motor inertia ratio/load to motor mass ratio
PB07 PG1 Model loop gain
PB08 PG2 Position loop gain
PB09 VG2 Speed loop gain
PB10 VIC Speed integral compensation
PB12 OVA Overshoot amount compensation
PB13 NH1 Machine resonance suppression filter 1
PB14 NHQ1 Notch shape selection 1
PB15 NH2 Machine resonance suppression filter 2
PB16 NHQ2 Notch shape selection 2
PB18 LPF Low-pass filter setting
PB19 VRF11 Vibration suppression control 1 - Vibration frequency
PB20 VRF12 Vibration suppression control 1 - Resonance frequency
PB21 VRF13 Vibration suppression control 1 - Vibration frequency damping
PB22 VRF14 Vibration suppression control 1 - Resonance frequency damping
PB23 VFBF Low-pass filter selection
PB47 NHQ3 Notch shape selection 3
PB48 NH4 Machine resonance suppression filter 4
PB49 NHQ4 Notch shape selection 4
PB51 NHQ5 Notch shape selection 5
PE41 EOP3 Function selection E-3