Mitsubishi Electric MELSEC iQ-R16MTCPU, Programming Manual

Page: 212 / 482

210
3 PARAMETERS FOR POSITIONING CONTROL
3.10 Override Data
3.10
Override Data
Override data is for using the override function.
[Motion Control Parameter]  [Axis Setting Parameter]  "Override Data"
*1 Refer to the indirect setting method by devices for parameters for the range of devices used for indirect setting. (

Page 168 Indirect
Setting Method by Devices for Parameters)
*2 This setting can be omitted.
Override ratio setting device
Set the device that sets the override ratio of the override function.
Set override ratio setting device to the override ratio values below.
Refer to override function for details of the override ratio setting device. (

Page 462 Override Function)
No. Item Default
value Setting range Direct
setting Indirect setting
*1
Reference
Section
mm inch degree pulse Valid/
invalid Valid/
invalid
(Required
size) Fetch
cycle
1 Override ratio setting
device
*2
   
(1 word)
Operation
cycle  Page
210
Override ratio
0 to 3000(

10
-1
[%])