EN-6
COMPLIANCE NOTICE OF FCC
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by Mitsubishi could void the user’s authority to
operate this equipment.
COMPLIANCE NOTICE OF INDUSTRY CANADA
This Class A digital apparatus complies with Canadian ICES-003.
Do not display the same image for a long time
When an image is kept displayed for a long time, it may be left on the screen (image persistence) after the
displayed image is changed. As long as the symptom is minor, the image persistence gradually disappears
as you display different images or stop using the product for a while by turning off the power. However,
when the same image is kept displayed for a too long time, the image persistence will remain on the
screen. Therefore, do not display the same image for a too long time. The repair of the image persistence
(image sticking) will be chargeable even within the warranty period.
Backlight used for the LCD panel
The backlight used for the LCD panel has a lifetime. Though the brightness of the backlight decreases
with the duration of use, the symptom is caused by the characteristics of the LCD panel and not a
malfunction.
Characteristics of the LCD panel
Moiré may occur or the screen response speed may vary depending on the ambient temperature or
the input video signal. These symptoms are caused by the characteristics of the LCD panel and not a
malfunction.
Dead pixels or always lit pixels of the LCD panel
The LCD panel is made using very precise techniques and has effective pixels of 99.99% or more. However,
0.01% or less of the pixels may be dead or always lit. Such symptom is not a malfunction.
Installation location
Do not install this product in a place where it is exposed to direct sunlight or in a humid or dusty place.
Doing so may cause a malfunction or shorten its lifetime. Furthermore, installing this product in a
location where the temperature varies significantly may accelerate the degradation of the LCD panel.
Since the panel surface is vulnerable to damage and scratches, do not push or rub it with a solid object
and handle it with care. Take care to prevent finger print stains on the panel surface. If the panel surface
gets soiled, gently wipe it using a dry absorbent cotton pad or a dry and soft cloth (cotton, flannel, or a
wiping cloth). Use a clean cloth and do not use the same cloth repeatedly.
It is recommended to clean the panel using water, IPA, and hexane.
Do not use ketone-type materials (such as acetone), ethyl alcohol, toluene, ethyl acid, or methyl chloride.
If you use a solvent, remove it completely after cleaning.
If a solvent or water splash enters inside the product or gets on the surface except for the LCD panel, the
product may be broken.
The damaged surface of the LCD panel can’t be repaired.
Precautions for using this product
Warning:
This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment
may cause radio interference.