When
D
In
M
Install the terminal cover.
6
Run the power cord and wires through the rubber bushing.
Then use the mounting screw to back the terminal cover on
the unit again.
Install the attached clip on the power cord, and then fix it
with the clip mounting screw.
Confirm that the power cord and wires are not pinched
anywhere.
Front panel cannot be installed if the wires are placed on
the terminal cover. Place the wires to the right side of the
cover.
7
2. Attach the drain tank.
(1)
(2)
(3)
Engage the groove of front panel on the unit.
Using the removed screws (2 pieces), install on the unit as it was.
Confirm that the front panel is fitted securely.
1. Install the front panel
5
(1)
(2)
(3)
(4)
(1)
(2)
(3)
Remove the wire sheath for 15 mm from the end.
Connect the ground wire using the ground screw,
provided at the right side of the terminal block, and
washer.
Use the washer at the position as illustrated at right.
Screw-tighten the power cord to the terminal block
securely.
Check, by pulling the wires, that they are securely fixed to
the terminal block.
Make wiring on the terminal block.
●
●
Installation (Continued)
Terminal block
Power cord
Ground wire
Ground screw
Washer
6
Drain tank
Front panel
Unit
Front panel
mounting screws
Terminal cover
Terminal cover
mounting screw
Power cord
Terminal block
Clip + Clip mounting screw
(Accessory)
JT-SB116EH-W-CA-IM_874HD7001-GB 06.12.9 2:13 PM ページ 7
