Mitsubishi Electric GOT SIMPLE Series, User Manual

Page: 275 / 310

18 BootOS and System Application Installation Using Data Storage
273
18
18
BootOS and System Application Installation
Using Data Storage
There are the following two types for the installation of BootOS and system applications using a data storage.
Installing when starting the GOT

Page 274 Installing when starting the GOT
All the system applications and project data stored in the data storage are transferred to the GOT when powering on the GOT.
This installing method is effective in the following cases.
• The GOT utility cannot be displayed.
• The system application is not installed.
Installing using the data control function (Utility)

Page 274 Installing when starting the GOT
By operating the utility, select the system application or project data stored in the data storage and transfer them to the GOT.
Precautions on installing BootOS, system applications
• Installing both BootOS and system applications
After completing BootOS installation, install system applications. When installing BootOS, the built-in flash
memory in the GOT is initialized and goes to the status at factory shipment. (All system applications and
project data are erased.)
BootOS is installed in the GOT at factory shipment. It is not necessary to install BootOS when not upgrading it.
• Installation cannot be interrupted.
Do not perform any of the following during a BootOS or system application installation.
Failure to do so may result in installation failure, causing the GOT malfunction.
Powering off the GOT
Pressing the reset button of the GOT
Removing the data storage
If the installation failure and the GOT malfunction occur, take the following action.
If BootOS installation failed:
Please consult your local Mitsubishi (Electric System) Service center or representative.
If the basic system application installation failed:

Page 274 Installing when starting the GOT