Mitsubishi Electric GOT SIMPLE Series, User Manual

Page: 263 / 310

16 GOT SELF CHECK (DEBUG)
16.3 FX3U-ENET-ADP Communication Setting Function
261
16
16.3
FX3U-ENET-ADP Communication Setting Function
In GX Works2, the communication set value of the FX3U-ENET-ADP stored in the CPU can be changed.
This function is not available when the communication set value of the FX3U-ENET-ADP is not set in advance in the CPU.
Communication setting in the CPU
In GX Works2, set in advance the communication set value of the FX3U-ENET-ADP to the CPU.
For the details of the communication setting, refer to the following.

FX3U-ENET-ADP User's manual
Specifications
System configuration
This section describes the system configuration of the FX3U-ENET-ADP communication setting function.
For the setting method in each connection form, used communication unit/cable and cautions on connection form, refer to the
following manual.

GOT2000 Series Connection Manual For GT Works3 Version1
■
Required basic system application
■ Connection type
( : Applicable, : Partly restricted, : Inapplicable)
■
Communication setting items
The table below shows the communication setting items and setting range.
*1 Set the value "0.0.0.0" when not using the subnet mask pattern and default router IP address.
Operating system Version
Basic system application -
Communication driver MELSEC-FX -
Function Connection type between GOT and controller
Name Description Direct CPU
connection GOT multidrop connection
FX3U-ENET-ADP communication
setting function The communication set value of the FX3U-ENET-ADP
stored in the CPU can be changed.
Communication setting items Setting range Remark
IP address 0.0.0.1 to 223.255.255.254 If a value outside the setting range is entered, the error message "SET
NUMBER IS INCORRECT." appears.
Subnet mask pattern
*1
192.0.0.0 to 255.255.255.252
Default router IP address
*1
0.0.0.1 to 223.255.255.254