Mitsubishi Electric FR-F800, Instruction Manual

Page: 143 / 834

Basic operation Basic operation procedure (PU operation)
FR-F800 4 - 13
4.5 Basic operation procedure (PU operation)
4.5.1 Operating at the set frequency (example: operating at 30 Hz)
NOTE Where is the frequency command source?
●
The frequency set in the frequency setting mode of the operation panel
=> Refer to section 4.5.1 (page 4-13).
●
The setting dial used as the potentiometer => Refer to section 4.5.2 (page 4-15).
●
The ON/OFF switches connected to terminals => Refer to section 4.5.3 (page 4-16).
●
Voltage input signals => Refer to section 4.5.4 (page 4-18).
●
Current input signals => Refer to section 4.5.5 (page 4-20).
NOTE Use the operation panel (FR-DU08) to give a start command and a frequency command.
Fig. 4-4:
PU operation mode
I002443E
Operation panel
(FR-DU08)