Mitsubishi Electric F920GOT-BBD-K-E, Hardware Manual

Page: 314 / 592

GOT-F900 SERIES (CONNECTION) Connection of MELSEC-Q Series PLC 11
11-24
11.7 Cable Diagram
This section explains cable diagrams to connect the GOT-F900 and the Q Series PLC.
1) Cable for the GOT and the Q Series PLC
F920GOT-K (5V type)
When connecting the F920GOT-K directly to the Q Series PLC, the below cable is required to transfer
screen data.
For caution on use, refer to section 6.4.
Composition of Q Series PLC connection
When connecting GOT-F900 to the Q series PLC directly, connects by the following cable.
Compoisition for translating screen data to GOT
When downloading/uploading the screen data to/from the F920GOT-K(5V type), the following power
cable is nessary for supplying 5V DC from the Q series PLC.
No. Model name Application Connection diagram Application
Q CPU direct
connection
Prepared by the user.
(Cable length 3m (9'10") or less)
Resistance per wire: 0.67
Ω
or less
(Approximately AWG 28 or thicker)
a)
RS-232C
connection
The connector figure shows the engagement face.
: Female type : Male type
GOT-F900
9-pin D-Sub, female
5 1
9 6
6-pin MINI DIN, male
Q Series
4
1
2
3
5
6
(2)
(3)
(5)
(6)
(4)
FG
(Grounding)
FG
(Grounding)
(8)
(9)
(2)
(1)
(3)
(6)
(5)
(4)
F920GOT-K Q Series PLC
RS-232C
Q CPU direct
connection
F920GOT-K
9-pin D-Sub, male
1 5
6 9
(5)
(9) (3)
(4)
No. Model name Application Connection diagram Application
GOT power cable
Prepared by the user.
(Cable length 3m (9'10") or less)
Resistance per wire: 0.67
Ω
or less
(Approximately AWG 28 or thicker)
b)
Power
connection
The connector figure shows the engagement face. : Female type : Male type
6-pin MINI DIN, male
Q Series
4
1
2
3
5
6
F920GOT-K
Personal computer
Q Series PLC
RS-422
Power cable
RS-232C
The cable for
screen data
transmission.