Mitsubishi Electric EW-50A, Installation And Instruction Manual

Page: 24 / 80

24
WT07936X05
7-3. Quick IP address (LAN1) setting
When connecting an EW-50 to a dedicated LAN system, IP address (LAN1) of the EW-50 can be easily set to an
address between 192.168.1.1 and 192.168.1.15 with rotary switch SW1.
When the IP address cannot be set with rotary switch SW1 (e.g., when connecting an EW-50 to an existing LAN,
when the EW-50 is used as an expansion controller of AE-200), set the IP address on the Web browser for Initial
Settings.
Set SW1 before turning on the power.
SW1
0 1 2
3
4
5
6
78
9A
B
C
D
E
F
* The arrow on the rotary switch indicates the current setting of the switch. Point the arrow at the desired number.
* To set the address, turn the rotary switch with a precision slotted screwdriver [2.0 mm (2/16 in) (width)] to a torque of less than
19.6 mN•m.
SW1 IP address (LAN1) Subnet mask Gateway
0
Default
192.168.1.1
Default
255.255.255.0
Default
0.0.0.0
1 192.168.1.1
255.255.255.0 0.0.0.0
2 192.168.1.2
3 192.168.1.3
4 192.168.1.4
5 192.168.1.5
6 192.168.1.6
7 192.168.1.7
8 192.168.1.8
9 192.168.1.9
A 192.168.1.10
B 192.168.1.11
C 192.168.1.12
D 192.168.1.13
E 192.168.1.14
F 192.168.1.15
Note
● If you forget the EW-50 IP address, check the IP address that has been entered on the monitoring PC (Web browser or
TG-2000A).
● If you forget the EW-50 IP address, you can start EW-50 by changing the SW1 setting and temporarily using a certain IP
address (between 192.168.1.1 and 192.168.1.15). The IP address can be changed to an arbitrary IP address by setting
the IP address on the Web Browser for Initial Settings, setting the SW1 back to “0”, and rebooting the EW-50. (It is
recommended to paste a label with the IP address on the EW-50, so that the IP address is available at all times.)