53
7.3
Verification of Settings
This function verifies whether the setting of Control Unit Engineering Tool is met with the one written to the parent terminal
of control unit.
It is useful when the written setting is lost or when you confirm the present setting before changing it.
*This function is available when the parent terminal is in the STOP status of control operation.
If you attempt to execute it in the RUN status, a message will appear to ask whether to execute after the status is changed
to STOP.
(1) Connect the parent terminal and the computer with a LAN cable.
*The
computer’s IP address must be set in order to be in the same network.
(2) Enter the password of the parent terminal.
*For the password, refer to
(3) Click the
Collation
button.
Compare the setting currently opened with Control Unit Engineering Tool with the one written to the parent terminal.
(4) After the comparison, the following message appears according to the result.
Click the
OK
button to close the window.
<Match>
<Mismatch>
