Mitsubishi Electric CC-Link IE-NZ2GNSS2-16DTE, User Manual

Page: 151 / 170

APPX
Appendix 5 EMC and Low Voltage Directives
149
A
Appendix 5
EMC and Low Voltage Directives
Compliance to the EMC Directive, which is one of the EU Directives, has been a legal obligation for the products sold in
European countries since 1996 as well as the Low Voltage Directive since 1997.
Manufacturers who recognize their products are compliant to the EMC and Low Voltage Directives are required to attach a
"CE marking" on their products.
Sales representative in EU member states
Authorized representative in EU member states is shown below.
Company: Mitsubishi Electric Europe BV
Address: Mitsubishi-Electric-Platz 1, 40882 Ratingen, Germany
Measures to comply with the EMC Directive
The EMC Directive specifies that "products placed on the market must be so constructed that they do not cause excessive
electromagnetic interference (emissions) and are not unduly affected by electromagnetic interference (immunity)".
This section summarizes the precautions on compliance with the EMC Directive of the machinery constructed with the
module.
These precautions are based on the requirements and the standards of the regulation, however, it does not guarantee that the
entire machinery constructed according to the descriptions will comply with abovementioned directives.
The method and judgment for complying with the EMC Directive must be determined by the person who constructs the entire
machinery.
EMC Directive related standards
■
Emission requirements
*1 QP: Quasi-Peak value, Mean: Average value
*2 The module is an open type device (a device designed to be housed in other equipment) and must be installed inside a conductive
control panel. The tests were conducted with the module installed in a control panel.
Specifications Test item Test description Value of standard
EN 61131-2: 2007 CISPR16-2-3
Radiated emission
*2
The electromagnetic waves emitted
by the product are measured. • 30 to 230MHz QP: 40dB

V/m
(measured at 10m distance)
*1
• 230 to 1000MHz QP: 47dB

V/m
(measured at 10m distance)
CISPR16-2-1, CISPR16-1-2
Conducted emission
*2
The level of the noise which the
product emits to the power supply
line is measured. • 0.15 to 0.5MHz QP: 79dB, Mean:
66dB
*1
• 0.5 to 30MHz QP: 73dB, Mean:
60dB