Electrical adjustment
33
Misc. 1 tab
Start memory
You can specify a display memory number (p. 31) to
be displayed at start-up. The initial setting is OFF.
The OFF setting displays the display memory that
was displayed just before turning off.
Auto power on
In ON setting, the connected power units
automatically start supplying the power to the LED
units when the control unit is turned on (p. 21). The
initial setting is OFF.
Active power peak saving
You can limit the maximum power consumption by
control unit. When a brighter content is displayed,
it automatically reduces the brightness not to
exceed the specified power consumption limit. The
initial setting is OFF.
If a certain level of brighter content is detected in
one of the control unit areas that have been set “On
(all)”, all these areas will be dimmed with keeping
the uniformity among them.
Set the same percentage in the “power control
level” column in these units.
Set the “Frame lock” function
（
p. 36
OFF when
you use the “On (all)” setting.
“On (single)” setting dims only the brighter
control unit area(s).
When the power unit loop is connected across
the control unit display area borders (p. 11), do
not use this function. It wouldn’t work properly.
In “Slow recovery mode”, the brightness slowly
recovers from the dimmed condition when the
brighter content area becomes less.
Inrush current suppression (180
Series)
In ON setting, the power is supplied to cascaded
LED units (p. 11) in series, which can curb excessive
inrush current that may arise instantaneously.
Brighter area
Summary of Contents for 12NP180 Series
Page 50: ......
