16
(2)
Flap control
Control the flap by AIRFLOW button on the wireless remote controller.
(a)
Natural flow (AUTO)
The flap will be automatically set to the angle of air flow best to operation.
(i)
Starting time of operation
(c)
Swing flap
Flap moves in upward and downward directions continuously.
Horizontal
blowing
(ii)
When not operating
The flap returns to the position of air flow directly below, when operation has stopped.
(b)
Memory flap
While the flap is operating if the AIRFLOW button is pushed once, it stops swinging at an angle.
As this angle is memorized in the microcomputer, the flap will be automatically set to the angle when next operation is
started.
¡
Recommendable stopping angle of the flap
Slant forward
blowing
COOL•DRY
HEAT
¡
The flap operation as shown above will be
repeated.
Stops at the level position for
one minute.
s
In case of cooling
t
and dry operation
Sway operation
S
40 models
¡
When the room temperature controller (ther-
mostat) is activated, horizontal blowing is ap-
plied to prevent cool wind from blowing out.
s
In case of heating
t
operation
Flap stops 3’50” on
this position.
Sway operation
S
50, 56 models
Stops for approximately
5 seconds in this
position.
Thick line : Rapid movement
Thin line : Slow movement
Thick line : Rapid movement
Thin line : Slow movement
Stops for approximately
5 seconds in the
horizontal position.
s
During cooling and
t
dry operation
s
During heating
t
operation
Summary of Contents for SRK408HENF-L3
Page 40: ...40 MEMO...
