Mitel MiVoice 5000, Installation Manual

Page: 25 / 28

21
PRI/T1/E1/J1 C
ARD
- S
TANDARDS
C
OMPLIANCE AND
D
ISCLAIMERS
C
HAPTER
6 C
OMPLIANCE
problem has been corrected or until you are sure that the equipment is not malfunctioning. This equipment
may not be used on coin service provided by the telephone company. Connection to party lines is subject
to state tariffs. This device is equipped with an USOC RJ-11C connector.
FXO Card – Innovation, Science and Economic Development Canada (ISED)
Disclaimer
The FXO card meets the applicable Innovation, Science and Economic Development Canada technical
specifications.
The Ringer Equivalence Number (REN) indicates the maximum number of devices allowed to be
connected to a telephone interface. The termination of an interface may consist of any combination of
devices subject only to the requirement that the sum of the RENs of all the devices not exceed five.
PRI/T1/E1/J1 Card - Standards Compliance and Disclaimers
The PRI/T1 card complies with Part 68 of the FCC Rules. On the underside of this equipment is a label
that contains, among other information, the FCC Registration Number, Ringer Equivalence Number
(REN) and USOC jack type for this equipment. You must, upon request, provide this information to your
telephone company. If your telephone equipment causes harm to the telephone network, the Telephone
Company may discontinue your service temporarily. If possible, they will notify you in advance, but if
advance notice is not practical, you will be notified as soon as possible. You will be informed of your right
to file a complaint with the FCC. Your telephone company may make changes in its facilities, equipment,
operations or procedures that could affect the proper functioning of your equipment. If they do, you will
be notified in advance to give you an opportunity to maintain uninterrupted telephone service. If you expe -
rience trouble with this telephone equipment, please contact Mitel for information on how to obtain service
or repairs. The telephone company may ask that you disconnect this equipment from the network until the
problem has been corrected or until you are sure that the equipment is not malfunctioning. This equipment
may not be used on coin service provided by the telephone company. Connection to party lines is subject
to state tariffs. This device is equipped with an USOC RJ-48C connector.
PRI/T1/E1/J1 Card – Innovation, Science and Economic Development
Canada (ISED) Disclaimer
The PRI/T1 card meets the applicable Innovation, Science and Economic Development Canada technical
specifications.
BRI Standards Compliance and Disclaimers
Category Specification
Telecom TBR3:1995 + A1:1997