Change the two Grip Clamps to the two Shaft Clamps.
Follow the instructions for changing the clamps on
page 17.
Place the butt of raw shaft into the Shaft Clamps flush
with the end of the clamp or adjust shaft position to
other desired clamping lengths.
Install the Shaft Weight onto the tip end of the shaft
and tighten the thumb screw to hold the Shaft Weight
in place. Be sure tip end of shaft is inserted into the
bottom of the Shaft Weight. See image 11-1.
Place The DigiFlex™ Meter with the Sensor directly
underneath the shaft, near the weight. You will get the
same correct CPM reading when placing the meter at
any point along the lower 1/3 of the shaft.
See image 11-2.
image 11-1
image 11-2
