Instruction Manual MIT-SCAN-T3
Version 02/2021
Page 33
3.3.3
Results display
After completing the measurement run, the traverse path curve
appears on display. In this graph the curve is scaled based on the
display and the adaption of the amplification. The curve should show
no irregularities. Irregularities are an indicator of disturbances during
measurement (s. Fig. 28).
The result is subsequently displayed (s. Fig. 29). The following
information is shown in display:
Measured layer thickness
Selected or automatically identified reflector
Material quality coefficient
If GPS data have been received on site, this is shown at the right
corner of display (s. highlighted area in Fig. 29).
3.3.4
Calculated layer thickness
The calculated layer thickness is displayed in the selected unit. The
measured value equals the distance between reflector bottom and the
contact surface of the probe.
Fig. 28 Measurement curve
Fig. 29 Display of
results with GPS icon
Summary of Contents for MIT-SCAN-T3
Page 2: ...Page 2...
