Fix metal spacer brackets to heater using
screw holes and screws provided (Fig. 5).
Present heater to wall bracket, engage and
push down (Fig. 6).
Operating The Heater
After finding a suitable location for your Heatstar
Convection Heater, roll out the cord, plug into a
power point and turn the knob to on.
Heat Settings
Switch on the heater by selecting ‘-’ or ‘=’ or both
‘-’ & ‘=’ together for your preferred amount of
heating power. Refer to Fig. 7.
‘-’ 750W, Economic Setting
‘=’ 1250W, Standard Setting
both ‘-’ & ‘=’ 2000W, Maximum Setting
Then set the thermostat by means of the
thermostat knob (as per Figure 8). Subsequently,
the heater will keep the surrounding air at the set
temperature by switching on and off at intervals.
You may adjust the thermostat during use.
To find the ideal thermostat setting for you, first
set the dial to maximum position. As soon as the
temperature is comfortable, turn the thermostat
to the direction of minimum position slowly, until
the heater goes off.
Fig. 7
Fig. 8
6
Fig. 5
Fig. 6
MCVH2000 Heatstar.p65
9/17/2001, 3:34 PM
6
