6
Plug each LX CONNECT Speaker in to the mains power supply and turn on the power switch to enter start up mode.
Upon initial power-on, the LED indicator will slowly flash green. This means the speakers are currently not
connected to any LX CONNECT Hub device - you will need to pair the speakers with hub (follow the LX CONNECT
Hub installation section).
After pairing, the LED light will remain illuminated green. After pairing for the first time, you will not need to do this
again when turning the system on or off.
Use the LEFT / MONO / RIGHT switch to assign each speaker’s output channel. LEFT / RIGHT options are designed
for a conventional stereo setup. Alternatively if you are placing the speakers around the room or living area in an
unconventional way, you can set the speakers both to mono if you wish.
The -6dB / 0 / 6dB switch attenuates the bass levels of the speakers. You can use this to adjust the sound to your
personal preference, and may find the bass will need reducing when placed near to a wall.
Please note:
- When the speakers are free standing on suitable stands, use the 0dB or +6dB bass setting
- When the speakers are placed close to a rear wall, use the 0dB setting
- When the speakers are shelf mounted, use the -6dB or 0dB setting
The UPDATE port is only used for updating the internal software or service purposes. This is a non-user serviceable
connection. Please refer to the Mission website or your Mission dealer concerning updates or service.
The PAIR button is used to connects the speakers and hub as a system. If you long press the button until the LED
indicator flashes then the software version will be displayed on the hub screen.
Installing & Operating the LX CONNECT Speakers
POWER /
PAIRING LED
PAIRING
BUTTON
UPDATE
SOCKET
AC INPUT
POWER
SWITCH
BALANCE
SYNC
BASS
SELECTOR
MODE
SELECTOR
