Mission Critical xantrex XPower 3000, Owner'S Manual, Page: 14 / 56

14 Xantrex XPower 3000 Owner's Guide
2 FEATURES
This section describes the different parts of the inverter.
AC Panel
9
4 3 5 6 7 8
1 2
REMOTE
POWER
PUISSANCE
FAULT
FAUTE
Non-sinusoidal
output only.
Non seulement de
sortie sinusoïdale.
1a
Figure 2 AC Panel
Feature Description
1 AC compartment with cover (1a) houses the AC terminal
block for hardwiring the inverter
2 GFCI-protected AC outlets
3 AC knockout Take the cover out when passing cables
(wires) through for hard wiring the inverter.
4 Reset button is used to reset the 20 A supplementary
(overcurrent) protectors.
5 Power light (green) indicates the inverter is operating.
6 Remote O
N
/S
TANDBY
Connector Port for connecting the
O
N
/S
TANDBY
remote switch.
7 Fault light (red) indicates that the inverter has shut down
due to inverter overload or over-temperature.
8 O
N
/S
TANDBY
Switch turns the inverter’s control circuit on and
in Standby mode. This switch is not a power disconnect
switch. Disconnect AC and DC power before working on any
circuits connected to the inverter.
9 Remote O
N
/S
TANDBY
Switch comes with 20 feet (6m) long
cable.
Table 1 AC/DC and GFCI Panel Features