Setting up:
How to use:
1. Set minimum fan speed on dial 1, set maximum fan
speed on dial 2. Fans will work between these parameters.
For the largest operating range, we recommend Min 20%
and Max 100%.
2. Set target temperature on dial 3.
3.
Night-Pulse™
Deactivated = Cap on. Activated = Cap
off.
Mains power must be off before activating or deactivating.
4. Switch on at mains.
5. Controller will enter a short period of calibration.
During this time, fans may pulse up and down. After
approximately 5 minutes, fans will find the right speed.
Plug
SuperSilent™
Temperature Controller into
mains socket. Leave the mains power switched off
until you have completed setup.
1
Plug input fan into socket 1, and outtake fan
into socket 2.
2
Position Temperature Sensor inside room at canopy height,
taking care to avoid places where it may take a false
reading, such as directly under lights, or in front of fan.
3
Position
Night-Pulse™
sensor inside room where it can
detect light. Do not put directly under light.
4
EN
Socket 1
Socket 2
INPUT
OUTTAKE
Deactivated
(Cap on)
Activated
(Cap off)
(Mains Power
OFF
before Deactivating or activating
Night-Pulse™
)
Dial 1
(Min Fan Speed)
Dial 3
(Temperature)
Dial 2
(Max Fan Speed)