Mirpol GRASSE, Assembly Instructions Manual, Page: 20 / 35

19 PL / EN / CZ GRASSE
9. Attach the suction cup to the table. Place
glass or lava stones (one pack) (M) over the
burner.
NOTE: do not cover the ignition part.
10. Connect the gas hose to the furnace and
the reducer, and then the reducer to the gas
cylinder. After placing the cylinder in the glove
compartment, secure it firmly with the locking
strap.
WARNING! Make sure the hose does not come into contact with hot surfaces as it may melt and leak, causing a fire.
The hearth gas connections are tested for leakage at the factory prior to shipment. In the place of
installation, a full gas tightness check should be carried out due to possible improper handling of transport
or application of excessive pressure to the system.
1. Mix 60-90 ml of leak detection fluid by mixing one part of the washing liquid with 3 parts of water.
2. Make sure the control valve is turned to „OFF”.
3. Connect the regulator to the gas cylinder and the ON / OFF valve to the burner. Make sure the
connection is there safe, then turn the gas ON.
4. Spray a soapy solution over the hose and all connection valves. If bubbles appear, there is a leak that
must be removed before using the device.
5. Check again after correcting the fault.
6. Turn off gas in cylinder after testing.
7. If the leak is found and cannot be repaired, do not try to rectify the fault yourself but consult your
local service center.
LEAK TEST
LOCATION OF THE HEARTH
• The hearth is intended for outdoor use only. Always make sure that there is adequate ventilation and
access to fresh air.
• Always maintain a sufficient distance from combustible materials, ie top 100 cm and sides of at least
100 cm.
• The hearth must be placed on an even, hard surface.
• Never use the hearth in an explosive atmosphere, eg in places where gasoline, other flammable
liquids or vapors are stored.