1
R084206, RevB
SC38NA™
FIGURE 1 - PREPARATION
From corner to centre line of stud
11 3/4”
298 mm
11 3/4”
298 mm
38”
965 mm
76 3/4” 1949 mm
5”
127 mm Ø Clearance
Blocking
38”
965 mm
From floor to centre line of blocking
mirolin.com
SORRENTO™ ONE-PIECE NEO ANGLE SHOWER
INSTALLATION INSTRUCTIONS AND OWNERS MANUAL
READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING THE INSTALLATION
PLEASE RECORD THE SERIAL NUMBER ________________ OF YOUR SHOWER
SAVE THIS MANUAL FOR FUTURE REFERENCE
INSTALLATION NOTES
Important:
The Acrylic Shower was carefully inspected and packed
for shipment. You should check your unit and if there are
any problems, contact your dealer before installation.
Protect the shower from dirt and damage by leaving the
polyethylene protective film in place until installation and
other related construction is complete.
Follow Local Building Codes.
PREPARATION
1. Install framing and blocking as shown in Figure 1.
2. Ensure that the floor is level, correct if necessary.
3. Figure 1 shows drain location and clearance.
Drain pipe must be vertical.
INSTALLATION
1. Place the unit into position and plumb vertical, shim if
necessary.
2. Dry fit drain to check position.
3. Mark and drill 1/4” (6 mm) pilot holes for fixtures.
4. Verify the holes are in the right location.
5. Remove the unit from the corner.
6. From the finished side of the unit, use the correct size
hole saw to cut the openings using the pilot holes as
guides.
7. Install the drain according to manufacturer’s
instructions. Use a mildew resistant silicone sealant
to seal the drain to the top surface of the base.
8. Move the shower into place.
9. Drill 1/8” (3mm) holes at approximately 8” (200mm)
intervals around the flanges as shown Figure 2.The
holes should go just through the fibreglass.
10. Use a level to ensure that the walls are vertical, shim
as necessary between the fibreglass walls and the
studs at the hole locations.
11. Use drywall screws to carefully fasten the shower to
the framing. Note that over tightening or burying the
head of the screw may cause the fibreglass to crack.
