258
Mirka® AROP-B 312NV & ARP-B 300NV • 77 mm (3") • 10.8 V
en | us • ca
Proper use of the tool
This polisher is designed for polishing all types of materials such as paints, metals, wood, stone, plastics, etc , using
polish specially designed for the given material Do not use this polisher for any other purpose than that specified
without consulting the manufacturer or the manufacturer’s authorized supplier Do not use backing pads with an
operating speed of less than 8,000 rpm free speed Any maintenance or repair work requiring the motor housing to be
opened may only be performed by an authorized service center
Battery and charger
• The battery pack is not fully charged out of the carton Read the safety instructions first and then charge the battery
accordingly
• For optimal charging capacity, the battery should be charged at an ambient temperature between 18 °C (64 °F) and
24 °C (75 °F) To prevent damage to the battery pack, do not charge where the air temperature is below 4 °C (39°F) or
above 40 °C (104 °F)
• For the longest possible battery life, we suggest the following:
– Store and charge your battery in a cool area Temperatures above or below normal room temperature will shorten
battery life
– Never store the battery in a discharged state Recharge it immediately after discharge
• All batteries gradually lose their charge The higher the temperature, the quicker this happens
If you store your tool for long periods of time without use, recharge the battery every month This practice will prolong
battery life
Charging procedure
• Connect the power cord to the charger and plug into an outlet before inserting the battery pack All three charging
lights will glow for two seconds and then go out
• Insert the battery pack into the charger
• During the charging process, the charging lights will indicate the status as follows:
– The three charging lights will flash in sequence during the charging process
– When fully charged, all three lights will glow steadily
• The charging process will last approximately 40 minutes for the BPA 10820, 50 minutes for the BPA 10825 and 100
minutes for the BPA 10850 battery pack
NOTE: This charger can only charge Mirka 10 8 V battery packs
NOTE: Charging times may be longer depending on the ambient temperature and battery condition
LED indication of 10.8 V charger
LED
3
2
1
Sta
tus
Pre-charge
(Trickle charge)
Charging…
Charging…
Charging finished
Over temperature
Battery failure
Steady glow
Flashing