WARRANTY
MIREMADI warrants this product to be free from defects in material and workmanship for a period of 90 days from date
of shipment.
During the warranty period, MIREMADI will, at its option, either repair or replace any product that proves to be defective.
To exercise this warranty, email support and you will be given prompt assistance and return instructions. Repairs will be
made and the product returned, transportation prepaid. Repaired or replaced products are warranted for the original
warranty period of 90 days.
LIMITATION OF WARRANTY
This warranty does not apply to defects resulting from product modification, or misuse of any product or part. This
warranty also does not apply to normal wear or failure to follow instructions on maximum input voltages and polarities.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE. THE REMEDIES PROVIDED HEREIN ARE
THE BUYER’S SOLE AND EXCLUSIVE REMEDIES.
NEITHER MIREMADI NOR ANY OF ITS EMPLOYEES SHALL BE LIABLE FOR ANY DIRECT, INDIRECT, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF ITS INSTRUMENTS EVEN IF
MIREMADI HAS BEEN ADVISED IN ADVANCE OF THE POSSIBILITY OF SUCH DAMAGES. SUCH EXCLUDED
DAMAGES SHALL INCLUDE, BUT ARE NOT LIMITED TO: COST OF REMOVAL AND INSTALLATION, LOSSES
SUSTAINED AS THE RESULT OF INJURY TO ANY PERSON, OR DAMAGE TO PROPERTY.
THIS DEVICE IS MADE FOR HOBBY USE AND SHOULD NOT BE USED IN SAFETY CRITICAL SYSTEMS.
SAFETY PRECAUTIONS
ALTHOUGH THIS DEVICE IS EYE SAFE, DO NOT LOOK IN TO THE IR SOURCE DIRECTLY FOR PROLONGED
PERIODS. DO NOT LOOK AT THE IR SOURCE WITH MAGNIFYING GLASS OR OTHER OPTICAL INSTRUMENTS. IF
THE DEVICE IS MALFUNCTIONING, DO NOT USE, REMOVE POWER AND CONTACT SUPPORT.
OPERATION
In normal use only the Main connector is required. Use the supplied connector and make sure that when plugged in the
black wire is at the edge of the box. Apply 11V to 14V across the black and red wires with negative connected to black
wire and positive to red wire. The white wire is the range signal output. It will supply 0-5V in to high impedance and
0-2.5V into a 1K Ohm load.
For additional control the AUX connector (user supplied) can be used. The SHUT DOWN pin can be asserted high (above
1.5V) to put the device in to low power mode. This input can be used for both 3.3V and 5V systems. If left unconnected
the module defaults to the active state (ON), and operates in normal power mode.
LDR-M10
INSTRUCTION MANUAL
