Mirapoint RazorSafe 700, Hardware Manual

Page: 69 / 98

Control Panel Assembly (Service-only Procedure)
63
Figure 31 Removing and Installing the Control Panel
Removing the Control Panel Board
c
Only trained service technicians are authorized to remove the appliance cover and
access any of the components inside the appliance. Before you begin this procedure,
review the safety instructions that came with the appliance.
To remove the control panel board:
1. Power off the appliance and attached peripherals, and disconnect the appliance
from the electrical outlet and peripherals.
2.
Open the appliance. See Opening the Appliance on page 30.
3.
Disconnect the display module cable from the control panel board ( Figure 31
on page 63).
4. Disconnect the control panel cable at back of the control panel board
(
Figure 31 on page 63).
5.
Disconnect the internal SD module cable.
6. Using a T8 Torx driver, remove the screw on the front panel located beneath the
left USB connector (
Figure 31 on page 63).
1 front panel screw (Torx) 2 display module cable
3 control panel board 4 control panel cable
5 mounting screws (3 Torx) 6 display module
5
2
3
4
6
1