ASD
ASD--711i/712i
711i/712i
9
2.4 Electrical installation
When connecting the ASD-711i or ASD-712i to external equipment, make sure that all digital
connections are point-to-point.
Refer to the figure below and to the following descriptions for a complete ASD-711i or ASD-712i
installation.
This equipment is conform to the CEE 89 / 336 directive and operation is subject to the following
two conditions:
1- This equipment may not cause harmful interference according to EN 50081-1
rules.
2- This equipment must accept any interference received, according to EN 50082-
1 rules.
Precaution of use:
Several components included are very static-sensitive. To avoid damaging those components,
be sure to respect the following rules:
1- Before touching any component or any other element of the card make sure to
reduce any static electricity on your person. One way to do this is to touch a
surface connected to ground, or to wear a wrist strap attached to ground.
2- When handling card, hold it by the edges avoiding touching the components.
Note:
ASD-711i corresponds to only channel 1; ASD-712i corresponds to channel 1 and 2. The
rear panel is always equipped with ASD-712i rear panel.
2.4.1 110
Ω
Ω
rear panel
Figure 4: 110
Ω
rear panel
AES
26 point HD Sub-D socket
Digital audio outputs and AES3 reference input
ANLG
15 point HD Sub-D socket
Analog audio inputs
REF.IN
BNC jack
Reference input
REM
RJ10 socket
GPI outputs
2.4.2 75
Ω
Ω
rear panel
Figure 5:
75
Ω
rear panel
OUT1, OUT2 BNC jacks
Digital audio outputs
REF.IN
BNC jack
Reference input
ANLG
15 point HD Sub-D socket
Analog audio inputs
REM
RJ10 socket
GPI outputs